Tuesday, October 4, 2016

Engine Update

Not a lot to report. I made some progress on the LNG facility. On a good note, after an extended hiatus, I've finally gotten back to locomotive building. I scratched one more of the list with the completion of NP 3617. This was a fun build using a 3D printed cab.
Finishing this engine leaves me one SD45 left to do, GN 400. That will probably wait until after I finish some BNSF power.


  1. Great Job Karl!
    That's a sweet scheme...
    What was the reason for using a 3D cab?

    1. Thanks Allen!
      NP used a four window cab and Kato only makes a 2 window cab. Using a 3D printed cab was a lot easier than trying to cut 4 extra matched windows.