Tuesday, June 2, 2015

More Skally Progress

I've been focusing my time on some engine builds. I've almost wrapped up the SD60F, I'm just waiting to get the decoder back from MRC (small headlight issue). While I was waiting I did add another detail to it, you may get to see that in an upcoming N Scale Railroading Article. I have also been working on some MILW GP20's that I am hoping to post pictures of when I get my next weekend.

Thinking I was going to be taking my Hinckley modules to Sacramento for the N Scale Enthusiast Convention, I have been spending a little time on them every day. As it turns out, there wasn't room for me, which may be a good thing for my time management right now.

I brought the 3 modules (yes, Hinckley grew by one module) out into the fresh air to check to see how they fit together.
The new South HIN module (old North end of Rush City) is re-ballasted and both tracks line right up to the Center HIN module.
Here is the Hwy 61 bridge over the Skally. I was primering some engines so I shot it with the same paint. Piers and bridge abutments are coming soon.
The fitment issue I ended up with was the joint between the Center and North HIN modules. It looks like I will have to do some work on the left side near rail. It broke loose from the PCB ties. The humidity and temperature differences between Nevada and MN took their toll. I don't think the movers were very gentle along the way either.
Looking down from above the old NP main line you can see the completed Skally Main Line and Interchange Track. Now that I know they fit I will finish the ballasting on the Center module. Then I will redo the ground cover and plant about 400 trees.
On the North Side of the North module I made the track that runs to the small BNSF MOW yard and to Federated Gas, which is served by the Skally. I was thinking of modeling the yard and Hinckley Depot that direction, but I am probably just going to run the track to the module edge and drop LPG cars behind the section house.
It's not much, but it's progress. I'll get the newly discovered problems fixed and be back to new stuff soon. Maybe next time I'll have one of my corners ready to show you!

2 comments:

  1. Can I ask what method you use for uncoupling when switching?

    ReplyDelete
  2. Of course you can! I use Rix Picks for uncoupling. I have them on my throttles so the are there when you need them. I remove all my trip pins as I find them to be a big source of headaches when left on.
    Thanks for asking!

    ReplyDelete